How to use solar light controller

Many field installers to get the solar light controller does not know how to operate, afraid to take the wrong line will result in controller failure, manual sometimes do not know where to throw, causing a lot of trouble. Now the solar street light controller to do a description of the wiring.

A: Matters needing attention

1. It is recommended to install the product indoors or in the light pole, please do rainproof measures.

2. It is recommended that the user install the controller and battery in the same place so that the controller can detect the temperature of the battery at any time. Adjust the charge and discharge parameters.

3. The controller is only suitable for solar panels. Can not be used for diesel generation, electricity, wind power charging control, otherwise it will cause damage to the controller.

Second: Wiring method

1. Wiring sequence: first connect the battery, set the load mode of operation, - then connect the solar panels - the final load

2 wire diameter: the smallest 2 square millimeters

3. The controller's internal battery and the positive solar panel are connected together, the voltage is consistent, so the positive battery and solar panels connected together, see (schematic)

4. Make sure that all terminals are in good contact.

You have interest , send mail to :sale3@olys-digital.com

This article  from OLYS  Co., Ltd., reproduced please note source.

Related product

100W lamp controller

Related article

what is solar charge controller