The use of solar light controller wiring order should be: first load, and then connect the battery, and finally connected to the solar panel. Connected to the battery, the controller idle indicator light, a minute later, the discharge indicator light, the load is turned on. Finally connected to the solar panels, the controller will be based on light intensity, into the appropriate working condition. If the solar panel has a charging current, the controller charging indicator light, into the charging state. Controller wiring do not change, according to the working status indicator to see the corresponding working status.

一： the use of solar panels Note:

1, when using the display, avoid other items to block the solar panels, otherwise it will affect the conversion efficiency.

2, Avoid hard objects hit the solar panels, otherwise it will lead to damage to the solar panel can not be used.

3, the best solar panels installed in the south (the northern hemisphere) tilt angle of 30 degrees.

4, the cleaning of solar panels is best to be cleaned once every six months, to keep the solar panel surface clean

二： the use of batteries Note:

1, buried boxes need to seal the role of water

2, the positive and negative battery is strictly prohibited short circuit, otherwise it will lead to damage to the battery can not be used

3, the battery life is generally 2-3 years, after this period should be promptly replaced.

三： the use of LED lamps Note:

1, to prohibit the LED lamps and other objects cast stone.

2, in strict accordance with the setting change lamp lighting control.

3, lighting tilt angle to make timely adjustments.

Related product

Remote controller charger

Related article

Dual time solar street lamp controller mode and function