1.5KW solar charge controller

Many users want to understand the solar charge controller for 1.5KW components, the general household emergency lighting photovoltaic system, with about 500W components on it. Some communication base stations, highway billboards, power is relatively large, you need a long run, it will use about 1.5KW components. 1.5KW / 24V PV modules, the current almost 42A, the proposed use of Olys 60A / 24V with LCD display high-power solar charge controller. Here's a brief introduction to this controller:

一: SNC60 Solar Charge Controller Features:

1. This product can automatically adapt to 12V and 24V systems.

2. Mainly used in off-grid solar power systems, such as: home solar power systems, ships, unmanned base stations, posts and so on.

3. Friendly man-machine interface, real-time display of charge and discharge of various parameters.

4. The user can set the strong charge voltage and battery low voltage protection voltage according to the actual situation.

5. Adopt three-phase PWM charging method. Strong charge - Balance charge - Float charge.

6. Load Output The button can be used to manually control the switch.

7. The product uses intelligent microcontroller design, all the workflow are software control, enabling high-precision, high reliability.

8. The efficient use of PWM charging mode to ensure battery work in the best condition, greatly extend the battery life, at the same time with high precision temperature compensation.

9. It has over charge, over discharge, electronic short circuit, overload protection, anti-reverse protection and other automatic control; the above protection are not damaged any part.

10. Very large radiator design to ensure that a variety of work environments

二: the use of precautions

1. The solar cell module generates electric current under the light. Even in the case of weak light, the solar cell module can generate high voltage. Before installation, make sure that the solar cell panel is covered.

2. Before installing the controller, make sure that the voltage on the solar panel and the voltage of the battery match the controller.

3. Do not touch all bare wires during installation.

4. Battery positive and negative can not short circuit, it is recommended that when installing the battery in series with a fuse.

5. Please do not use inferior raw materials. Such as wire, screw.

6. Maintain the ventilation and cooling effect of the controller installation location. The controller generates heat during operation. Failure to do so may result in malfunction and fire.

7. Do not install the controller in a damp environment, if it must be installed, please do moisture-proof waterproofing.

8. Keep children away from the PV system.

The above information provided by the Shenzhen Olys Technology Co., Ltd.

Shenzhen Olys Technology Co., Ltd. for 12 years focus on the development and manufacture of solar controller, master the solar controller core, cutting-edge technology, service more than 300 new energy companies.

If you have in terests for solar charge and have any concern , please send mail to Anna:sale2@olys-digital.com, Whatsapp:+8615367961529

Related product

60A PWM controller

Related article

PWM VS MPPT solar charge controller