Solar charge controller working hours setting method

Solar charge controller running time is not running according to the clock, because there is no built-in clock controller, the light is turned on and off the lamp by monitoring the value of the solar panel current to trigger the light-on circuit, and now the new solar controller Support multi-time regulation, can be divided into time-zone set luminaire luminescence power, should be adjusted according to actual needs. What are the current solar charge controller which working hours have the setting method?

Solar charge controller working hours setting method:

Press the key for more than 3s, the digital tube begins to blink, and then the system will adjust the mode, and then release the key. Each time the key is pressed, the digital tube will change a number until the digital tube displays the number Select the mode corresponding to the figure, and other digital tube to stop flashing or press the button 3s or more to complete the set.

Solar street light controller working time setting:

Manual Mode: This mode is where the user may press the buttons themselves to turn the load on and off regardless of whether it is day or night. This mode is used for occasions with special load or during debugging.

Debug mode: used for system debugging, the light will automatically shut down the load, automatically turn on the light load, to facilitate the installation and commissioning check the correctness of the system installation.

Normally open mode: the power load has been kept output state, this mode is suitable for the load needs 24 hours. Although the display method varies from manufacturer to manufacturer, their settings are the same as long as you set it against your manual.

Light control mode: When there is no sunlight, the light intensity will drop to the starting point. After confirming the starting signal by controller for 10 minutes, the load will be automatically turned on according to the setting parameters of the working mode, and the load starts to work. When there is sunlight, the light intensity Raise the starting point, the controller delay 10 minutes to confirm the signal is turned off and the output is off, the load stops working.

Light control + time control mode: set the time of 1 to 14 hours. Start-up and shutdown process and pure light control the same, when the load to set the time will automatically shut down.

The above information provided by the Shenzhen Olys Technology and Technology.

Shenzhen Olys Technology 12 years focused on the development and manufacture of solar controller, master the core of solar energy controller, cutting-edge technology, service more than 300 new energy companies.

If you have in terests for solar charge and have any concern , please send mail to Anna:sale2@olys-digital.com, Whatsapp:+8615367961529

Related product

12V / 24 universal controller

Related article

Solar charge controller waterproof rating